. Electrical Specification電氣規格:
	1.1 Input Electrical Characteristics（輸入特性）
	Table 1：
Input voltage range 輸入電壓	
90Vac to 264Vac
Normal voltage range標稱輸入	100Vac to 240Vac
Frequency range    頻率范圍	50Hz/60Hz±5%
Max input  AC current
較大輸入電流	2 Amax at full load condition
Inrush current (cold start)
浪涌電流	50Atyp peak, 100Vac;60Atyp peak, 220Vac
Efficiency (full load)     效率	Type 95% 220Vac input 
Leakage Current    泄漏電流	Less Than 0.75mA, 240Vac input
額定功率	150W
Input Fuse         輸入保險	T6.3AH/250Vac
	1.2 Output Electrical Characteristics（輸出特性）
	1.2.1   Output Voltage & Current Regulation（輸出電壓電流調整率）
	Table 2  
Output Voltage
輸出電壓	Regulation
調整率	Min. current
較小電流	Rated current
額定電流	Peak current
峰值電流	Remark
備注
	+38V	±5%	0.0A	4.**	5.**	”V+”,”V-“
					
	
	Note:* The testing of peak current shall be performed under other dc output load rating and the peak current pulse width within 100ms conditions.峰值電流的測試條件是其它負載為額定負載，且脈寬小于100毫秒。
	      When  is tested(power test only),testing shall be performed with rated load current of  firstly, and then with load current of inverter. 
DC Output Ripple & Noise. （輸出紋波和噪聲）
	Table 3
	Output Voltage		Ripple & Noise (Max.)
+38V	380mVp-p@25℃
	   Note: 1)Ripple & Noise test: Ripple & Noise bandwidth is set to 20MHz. 
	           紋波和噪聲測試：紋波和噪音帶寬設置在20兆赫茲。
	        2)Use a 0.1uF ceramic capacitor in parallel with a 10uF electrolytic capacitor at output connector terminals for ripple & noise measurements.
	          輸出端并聯一個0.1uF的陶瓷電容和一個10uF的電解電容來測試紋波和噪聲。
	1.2.3  Output Transient Response. （輸出動態響應）
	   Table 4. Test condition.測試條件
Voltage Tolerance Limit	Slew Rate	Load Change
+38V/10%
	0.2**/uS	Min. to 50% load and 50% to Max load
	  Note:  Load change repetition rate: 50Hz to 100Hz . 跳變負載頻率:50~100Hz.
DC Output Overshoot During Turn-On & Turn-Off（輸出**調）
	Table 5
Output Channel	Output(V)	Overshoot voltage(V)**調電壓
			Turn-on開機		Turn-off關機
	+38V		+38V	≤10%	≤10%
	 Note:  All of dc output current from Min. to Max. 測試時負載范圍：較小到較大。
DC output voltage rise time（輸出上升時間）
	Table 6
Output Voltage		175Vac input &Full Load		220Vac input &Full Load
+38V	≤30 mS	≤30mS